Carpet Laying Tips

Should you ever have cause to remove the carpet you will find that the paper will stop the underlay or foam backing sticking to the floor.

Carpet laying tips.

Next place the carpet pad within the tack strip layout and then staple it to the subfloor. It s also a great way to reduce draught atop floorboards. Keep the padding within the inner perimeter formed by the strips. This is so good you might want to pull up your.

If you floor is concrete or has previously been levelled with a smoothing compound then this can pull up off the floor and may require re smoothing or levelling. The first rule when laying carpet is to use some double sided tape to hold down sheets of paper to the floor. A gap of around 50mm should be left around the perimeter of the room to allow you to stick double sided carpet tape to the floor. Padding should touch the edge of the tackless strips but should not.

You can seal the joints that form where two pieces meet with duct tape. This will protect the carpet from any dirt blown up from between the boards and will stop rubber or foam backed carpets sticking to the floor. Our homefit service will no longer be available from the 9 july 2018. Lay the carpet correctly.

Fitting carpet with integral underlay cover the floor with a paper underlay. The pad is easy to trim with a utility knife. Any existing orders will be honoured until 14 december 2018. Do not lay the padding over the tackless strips.

Even though it s n. Loosely lay out the carpet in approximately the correct position. The bolster chisel will help you attach the carpet on the opposite wall. In many cases laying tongue and groove floor boards is the most effective way to prep the floor for a new luxury carpet.

Unroll the carpet and attach to the gripper strips on one side of the wall then work from the center of the room to smooth and stretch the carpet. Don t replace carpet or any flooring before performing this simple trick.